woodworking lego box | Music Box continued

woodworking lego box

Hi Everyone,
Well, the wood shop is bloody cold today but I had a break in my day and so I decided to go down and work on the music a little more. Here are todays photos:
Here is the turning blank. Ive decided to shorten the box portion to 4 inches and Ive cut a groove in the bottom to mark this off:

This is the first chance Ive had to use the new jaws for the Nova chuck. The tenons on the ends of the blocks will fit into the jaws. This will hold the blocks securely while Im turning:

I took the turning block over to the bandsaw and cut the block into two pieces, the box portion and the lid:

Next, Im going to turn a tenon onto the box. Ive marked off a 1/4 tenon and Im going to use the bedan tool to cut it:

Hmm, this looks too small for a tenon. Not enough wood for the lid to sit on. Im going to enlarge it to 1/2" inch instead:

Here it is a few minutes later:

 Ive swiveled the tool rest over and Im beginning to hollow out the box portion. Id like to hollow it out to about 2 or 2 1/2". I was turning and as I was turning, my hands just began to freeze over and I couldnt hollow much more than about 1 1/4"--I just cant hold onto the handle of the turning chisel. So Im going to stop and go in and let my hands defrost. Ill continue on later next week when it warms up some.

Stay tuned,
VW

Do you find information about woodworking lego box are you looking for? If not, below may help you find more information about the woodworking lego box. Thank you for visiting, have a nice day.